Pump control EASY Small for 230V Press Flow Control. Pedrollo

Electronic pump control Easy Small - PEDROLLO PRESS FLOW CONTROL

Press-flow sensor for switching well pumps and cistern pumps for irrigation.
The Esay Small can switch pumps with a motor power of up to 1.5 KW, has a
integrated dry run protection and a fixed switch-on pressure of 1.5 bar.
The Pres-Flow module is ready to plug in and ready to use.

Description Pedrollo pump control Easy Small

Flow and pressure sensor suitable for the control and protection of single-phase well and cistern pumps up to 1.5 kW (for domestic applications). The control starts the pump when the system pressure drops. The pressure drop can be caused by a solenoid valve activated by an irrigation computer, or when water is drawn manually from a water outlet or faucet.
After closing the solenoid valve or the tapping point, the pump stops as soon as the flow in the main line drops below the value of 2 l / min.

CHARACTERISTICS

Type of liquid: clean water
Area of use: domestic
Applications: Irrigation, water supply systems , pressure systems.
Typology: Accessories
Family: Easysmall-Easypress-Presflo Multi
Maintenance free and space saving
Easy installation and Operation

PERFORMANCE RANGE

- Max. Flow rate: 200 l/min (12 m3/h)
- Max. Operating pressure: 10 bar
- Cut-in pressure: 1.5 bar

OPERATING RANGE

- Temperature of the liquid to be pumped +50 °C
- Ambient temperature up to +40 °C
- Bursting pressure 40 bar
- Protection class: IP 65
- Voltage: 230 V - Frequency: 50/60 Hz
- Max. Current: 16 A

CONSTRUCTION AND SAFETY STANDARDS

- Tropicalized and easily replaceable printed circuit board for complete protection against humidity, built into the housing with IP 65 protection class
- The board inside the EASYSMALL has been subjected to the most stringent EMC tests of electromagnetic compatibility (low emission and high immunity to interference) to ensure reliable use anywhere
- EASYSMALL including pressure gauge

INSTALLATION AND APPLICATION

The flow and pressure sensor is used to control and protect single-phase pumps up to 1.5 kW (for domestic use). The pump is started when the system pressure drops (e.g. when a tap is opened) and stopped when the flow drops to less than 2 l/min (tap closed). The Easy Small is equipped with an integrated check valve. The module can be mounted vertically as well as horizontally. The maximum height difference between the EASYSMALL control unit and the highest tapping point may be 11m. The Easy Small can be installed in an environment with up to 90% air humidity due to its encapsulated design, e.g. also in a well shaft.

RECOMMENDED ACCESSORIES IN ADDITION TO STANDARD INSTALLATION

To avoid frequent restarts, we recommend the installation of a small expansion tank.

APPLICATION:

The Pedrollo Easy Small pump control is suitable for installation in home garden irrigation projects together with a well pump or cistern pump The pump control is ideally suited for pressure and flow dependent control of the pump in the field of: water delivery from rainwater cisterns and wells, home garden irrigation with lawn irrigation, hedge and bed irrigation, wells with clear water as free of sand / low in sand as possible.

SCOPE OF DELIVERY PEDROLLO EASY SMALL:

Pedrollo Easy Small pump control
Ready to use wiring
Pedrollo manual

INSTALLATION INSTRUCTIONS:

The Pedrollo Easy Small pump control can be mounted either on the discharge port of the pump or anywhere within the permanent pressure line between the pump and the main valve or pump and valve well in an irrigation system. No tapping points should be installed between the well or cistern pump and the Easy Small, otherwise water would be tapped in the metering area. A horizontal or vertical outlet of the module is possible by simply screwing it over.