Aquila Jet Spike 310 mm 180° Black Cap Red Base

Aquila Jet Spikes 310 mm 180° black cap red base

These two-piece micro-spray nozzles can demonstrate an excellent watering pattern, allowing water to be evenly distributed over the area being irrigated.

This product is pre-assembled jet spikes with Aquila inserts. The rotation of the Aquila rotor allows you to adjust the flow rate and also allows you to adjust the throw. The height of the jet spike is 310 mm, but you can still raise or lower the jet spike to some extent.

Optimal performance is possible even at low operating pressure. Due to the wings, the bases of the sprayers can be easily installed by hand without any additional tools, so that subsequent replacement is not a problem, should a different spray pattern or angle be required.

The flow rate at 0.5 bar water pressure is 58 L/h, with a throw distance of 1.9 meters. As water pressure increases, a higher flow rate and further throw distance can be achieved (130 L/h and 3.3 meter throw distance at 2.5 bar). The Idra models can be used up to 2.5 bar, where 1 bar is the recommended working pressure.

The Aquila Jet Spikes are ideal for green areas and garden beds.

Dimensions

• Height: 515 mm
• Width: 70 mm
• Depth: 17 mm

Specifications

• Recommended pressure range: 1 bar
• Maximum pressure load: 2.5 bar
• Throw distance: 1.9 meters (0.5 bar); 3.3 meters (2.5 bar)
• Flow: 58 L/h (0.5 Bar); 130 L/h (2.5 Bar)
• Spray angle: 180°
• Connection: Barb for micro hoses