Plug&Rain ECO filter unit (without main valve!) for wall mounting 25 mm

Wall Mounting Filter Unit, 25 mm (3/4") Plug&Rain® Eco

Dirt particles such as grains of sand, rust from corroded supply pipes or lime sediments are very often found in tap water. The dirt contamination load is even higher for well and cistern water. These pollutants can disrupt the function of your irrigation system and thus cause damage to your garden, especially during an extended period of unattended operation. With a Plug&Rain® filter unit you can significantly increase the reliability, operational safety and life expectancy of your irrigation system.

The ECO Wall Mounting Filter Unit in our Plug&Rain® System is a simple filter unit without a main valve and compressed air drain.
The filter unit with a mesh size of 120 microns reliably protects your irrigation system from contamination and allows flow rates of up to 5 m³/h.
If the filter is clogged - indicated by the decreasing operating pressure of the irrigation system - you can simply rinse it after opening the filter cap.

Please note that the Eco filter units are not pre-assembled!

Included in the set:

• Rain Bird plastic basket filter unit with stainless steel filter body 120 mesh, up to 5 m³/h
• Standard pressure fitting for 25 mm (3/4") PE pipe
• 1" Dura Hard PVC screw Fitting
• Attachment kit for wall mounting

Technical Data:

• Installation dimensions ca.: width: 45 cm, depth: 10 cm, hight: 18 cm
• Pressure resistance up to 10 bar at 20°C

The Plug&Rain® filter units are intended for outdoor use only.