Plug&Rain assembly unit Filter unit with main valve for underfloor 32MM PREMIUM - THE BEST FOR YOUR GARDEN.

Filter unit with brass main valve underfloor in uncompromising Plug&Rain Premium Quality

Design with 32 mm (1") inlet and outlet

Dirt particles such as grains of sand, rust from corroded supply pipes or lime precipitates are very often found in tap water. The dirt load is even higher in well and cistern water. These impurities can disrupt the function of your irrigation system and thus cause damage to your garden, especially during a longer absence. With a Plug&Rain® filter unit you can significantly increase the reliability, operational safety and life expectancy of your irrigation system.

With the Premium underfloor filter unit in the Plug&Rain® system, you get a filter unit of uncompromisingly high quality with an extended range of functions thanks to a manual shut-off valve, an electrically operated main valve and access for compressed air. The parts are ready to install in a handmade deep black box, which can be installed above or below ground.
The large-volume filter unit with a mesh size of 130 microns reliably protects your irrigation system from contamination and keeps the pressure loss extremely low even at high flow rates.
If the filter becomes clogged - indicated by a drop in irrigation system operating pressure - you can simply flush it clean after opening the valve on the filter's lid.
The indestructible Hunter IBV main valve made of brass is opened via your Plug&Rain® control unit and automatically depressurises your entire system outside of watering times. This significantly increases operational reliability.
For winter storage, you can drain your entire irrigation system conveniently and professionally via the compressed air access.

Built-in components:
- Plastic screen filter unit from Rainbird with stainless steel filter body 130 micron, up to 20 m³/h
- 1" (ø 33.25 mm) brass ball valve as manual shut-off valve
- High end brass valve IBV 101 from Hunter with flow regulation
- Compressed air drain with valve and compressed air coupling
- High quality brass connectors for 32 mm (1") PE pipe inlet and outlet
- Noble 1" (ø 33,25 mm) brass screw connectors
- Electrical connection set with waterproof quick connectors

Technical data:
- Installation dimensions approx.: W: 57 cm, D: 39 cm, H: 26 cm
- Pressure resistance up to 8 bar at 20°C

The Plug&Rain® filter units are intended for outdoor use.