Underground Filter Unit in Economical Plug&Rain® Eco Quality
Designed for 32 mm (1") PE Pipes
Dirt particles such as grains of sand, rust from corroded supply pipes or lime sediments are very often found in tap water. The dirt contamination load is even higher for well and cistern water. These pollutants can disrupt the function of your irrigation system and thus cause damage to your garden, especially during an extended period of unattended operation. With a Plug&Rain® filter unit you can significantly increase the reliability, operational safety and life expectancy of your irrigation system.
The Plug&Rain® Eco underground filter unit is a simple filter unit, which can be installed underground in the box supplied.
The filter unit with a mesh size of 120 mesh reliably protects your irrigation system from contamination and allows flow rates of up to 5 m³/h.
If the filter is clogged - indicated by the decreasing operating pressure of the irrigation system - you can simply rinse it after opening the filter cap.
Included in the set
- Round plastic installation box, pre-drilled
- Plastic basket filter unit with stainless-steel filter body 120 Mesh, up to 5m³/h
- Standard pressure fitting for 32 mm (1") PE pipe
- 1" (ø 33.25 mm) Dura Hard PVC screw fitting
Technical Data:
- Installation dimensions ca. width 45 cm, hight 18 cm, depth 10 cm; box: Ø 32 cm, hight: 26 cm
- Pressure resistance up to 10 bar at 20°C
The Plug&Rain® filter units are intended for outdoor use only.
- Quality level: ECO
- Pipe system: Inlet 32 mm (1" inch)Output 32 mm (1" inch)
- Voltage: 24V AC control voltage
- Shipping weight: 4,02 kg
- Item weight: 4,02 kg